Back to Vaillant Fault Codes

Vaillant F27 Fault Code

This page contains the information required to help repair and diagnose the fault codes being shown on the boiler display. The following information, will take you through the fault finding sequence or steps, for rectifying a Vaillant Ecotec boiler with this fault code. Suggested solutions will be detailed further down the page.

F.27 Meaning

According to the installation and servicing instructions manual, “safety switch-off: Flame simulation”.  Also according to other sources, “Incorrect Flame Detection Fault (Flame Detection Even Though The Gas Valve Is Off)”

 

Cause of F27

According to the installation and servicing instructions manual. there is moisture on the electronics, electronics (flame monitor) defective, gas solenoid valve leaking. According to vaillant the causes are as follows.

  • Damage On The Electrode Or The Ignition Lead
  • Moisture Present On The Electronics
  • Fault On The Spark Generator
  • Fault On The Main PCB
Vaillant PCB X20 Connector
Vaillant PCB X20 Connector

Part Nos

Vaillant Electrode 090709
Vaillant Electrode 090709
Disclaimer: Information on this website is provided for informational purpose therefore we cannot accept liability for subsequent problems. All repair tasks should be carried out by qualified trades people. We may also receive commission payments when you are taken to external websites and complete purchases from third party sellers, once you leave our site, we cannot be held liable for your purchases.